HP E1563A User Manual page 107

DIAGnostic
:DAC:OFFSet[<channel>] <voltage>
:DAC:OFFSet[<channel>]:RAMP <count>
:DAC:GAIN[<channel>] <value>
:DAC:SOURce <voltage>
:DAC:SOURce:RAMP <count>
:INTerrupt:LINE 0 | 1 | 2 | 3 | 4 | 5 | 6 | 7
:INTerrupt:LINE?
:MEMory:SIZE <size>
:MEMory:SIZE?
:PEEK? <reg_num>
:POKE <reg_num>,<data>
:SHORt[<channel>] ON | 1 | OFF | 0
:SHORt[<channel>]?
:STATus?
FORMat
[:DATA] ASCii | PACKed | REAL
[:DATA]?
INITiate
[:IMMediate]
:CONTinuous ON | 1 | OFF | 0
:CONTinuous?
INPut[<channel>]
:FILTer[:LPASs]:FREQ 1.5K | 6K | 25K | 100K (4-chan)
:FILTer[:LPASs]:FREQ?
:FILTer[:LPASs][:STATe] ON | 1 | OFF | 0
:FILTer[:LPASs][:STATe]?
[:STATe] ON | 1 | OFF | 0
[:STATe]?
OUTPut
:TTLT<n>:SOURce TRIGger | SAMPle | BOTH
:TTLT<n>:SOURce?
:TTLT<n>[:STATe] ON | 1 | OFF | 0
:TTLT<n>[:STATe]?
Command Description
Troubleshooting commands.
Set offset voltage for the DAC.
Output offset ramp from the DAC.
Set DAC gain as specified.
Output specified DAC voltage.
Output ramp from the DAC.
Sets the interrupt line used ("0" =none).
Sets new value when you upsize RAM.
Query contents of a register.
Write data to a register.
Connect internal short to the channel.
Query interrupt sources register status.
Set data format.
Initiate a measurement now.
Initiate measurements continuously.
Set the input filter and enable/disable.
E1564A only; E1563A has fixed 25K.
Enable/disable channel's filter.
Enable/disable channel's input.
Define TTLTrigger lines 0-7 to output
trigger and/or sample signal.
Enable/disable the specified output.
107