Table of Contents
Advertisement
Attention: Do not allow the server to fall over.
Step 4.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 39).
Step 5.
Remove the air baffle (see "Removing the air baffle" on page 40).
Step 6.
Touch the static-protective package that contains the fan to any unpainted metal surface on the
server; then, remove the fan from the package.
Step 7.
Locate the rear fan position of the server chassis (see step 1 in the following illustration).
Step 8.
Insert two tabs of the rear fan into the holes of the server chassis, and rotate the rear fan to click
into the server chassis (see step 1 in the following illustration).
Step 9.
Connect the rear fan power cable on the system board. (see "Internal Cable Routing and
Connectors" on page 172).
Installing the air baffle
Use this information to install the air baffle.
Note: When you install the second microprocessor, you must also install fan 2 and the air baffle that come
with the second microprocessor upgrade kit.
To install the air baffle, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page
36.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3.
Remove the left-side cover (see "Removing the left-side cover" on page 39).
Step 4.
Slide the air baffle down into the server until the positioning pins fit into the locating holes; then,
gently press the air baffle down until the pinch tab clicks into place.
.
Chapter 2
Installing optional devices
87
Advertisement
Table of Contents
Troubleshooting
