Table of Contents
Advertisement
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables as necessary to replace the
device.
Step 3.
Disconnect all external cables and power cords.
Step 4.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
Step 5.
Remove the left-side cover (see "Removing the left-side cover" on page 193).
Step 6.
Remove the air baffle (see "Removing the air baffle" on page 195).
Step 7.
Remove the fan assembly (see "Removing the fan assembly" on page 267).
Step 8.
The USB connector and operator information panel assembly shown as the illustration.
Step 9.
Press the handle and pull the USB connector and operator information assembly backward out of
the server shown as the illustration.
Step 10. If you are instructed to return the USB connector and operator information assembly, follow all
packaging instructions, and use any packaging materials for shipping that are supplied to you.
238
System x3300 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
