Table of Contents
Advertisement
To log on to the IMM Web interface, complete the following steps:
Step 1.
Open a Web browser on a computer that connects to the server and in the Address or URL field,
type the IP address or host name of the IMM to which you want to connect.
Note: If you are logging on to the IMM for the first time after installation, the IMM defaults to
DHCP. If a DHCP host is not available, the IMM assigns a static IP address of 192.168.70.125. The
MAC address tag provides the default hostname of the IMM and does not require you to start the
server.
Step 2.
On the Login page, type the user name and password. If you are using the IMM for the first time,
you can obtain the user name and password from your system administrator. All login attempts are
documented in the event log.
Note: The IMM is set initially with a user name of USERID and password of PASSW0RD (passw0rd
with a zero, not a the letter O). You have read/write access. You must change the default password
the first time you log on.
Step 3.
On the Welcome page, type a timeout value (in minutes) in the field that is provided. The IMM will
log you off of the Web interface if your browser is inactive for the number of minutes that you
entered for the timeout value.
Step 4.
Click Continue to start the session. The System Health page provides a quick view of the system
status.
Enabling the remote presence feature
Use this information to enable the remote presence feature.
To enable the remote presence feature, complete the following steps:
Step 1.
Install the Integrated Management Module Advanced Upgrade.
Step 2.
Turn on the server.
Note: Approximately 1 to 3 minutes after the server is connected to ac power, the power-control
button becomes active after the power-on LED flashes slowly.
Reactivate any Features on Demand features after replacing the system board. Instructions for automating
the activation of features and installing activation keys is in the Lenovo Features on Demand User's Guide. To
download the document, go to
Enabling the Intel Gigabit Ethernet Utility program
Use this information to enable the Intel Gigabit Ethernet Utility program.
The Intel Gigabit Ethernet Utility program is part of the server firmware. You can use it to configure the
network as a startable device, and you can customize where the network startup option appears in the
startup sequence. Enable and disable the Intel Gigabit Ethernet Utility program from the Setup utility.
Configuring the Gigabit Ethernet controller
Use this information to configure the Gigabit Ethernet controller
The Ethernet controllers are integrated on the system board. They provide an interface for connecting to a 10
Mbps, 100 Mbps, or 1 Gbps network and provide full-duplex (FDX) capability, which enables simultaneous
transmission and reception of data on the network. If the Ethernet ports in the server support auto-
negotiation, the controllers detect the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T) and
duplex mode (full-duplex or half-duplex) of the network and automatically operate at that rate and mode.
106
System x3300 M4 Installation and Service Guide
https://fod.lenovo.com/lkms
, log in, and click Help.
Advertisement
Table of Contents
Troubleshooting
