Table of Contents
Advertisement
Installing a USB embedded hypervisor flash device
Use this information to install a USB embedded hypervisor flash device.
To install a hypervisor flash device, complete the following steps:
Step 1.
Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page
36.
Step 2.
Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
Step 3.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
Step 4.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 39).
Step 5.
Remove the air baffle (see "Removing the air baffle" on page 40).
Step 6.
Unlock the retention latch by pushing it down toward the system board.
Step 7.
Align the flash device with the USB connector on the system board and push it into the USB
connector until it is firmly seated.
84
System x3300 M4 Installation and Service Guide
Advertisement
Table of Contents
Troubleshooting
