Lenovo x3300 M4 7382 Installation And Service Manual page 236

14. Close the adapter-retention bracket.
15. Perform any configuration tasks that are required for the adapter.
If you have other devices to install or remove, do so now. Otherwise, go to "Completing the installation" on
page 85.
To replace an adapter on the PCI-X riser-card assembly, complete the following steps:
Note: If your adapter was previously configured, back up or record its configuration information, if possible,
before replacing the adapter. See the documentation for your adapter for information and instructions.
1. Read the safety information that begins in "Safety" on page v and "Installation guidelines" on page 169.
2. Turn off the server (see "Turning off the server" on page 24) and all attached peripheral devices.
Disconnect all power cords; then, disconnect all external cables from the server.
3. Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
4. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 193).
5. Remove the air baffle (see "Removing the air baffle" on page 195).
6. Remove the fan assembly (see "Removing the fan assembly" on page 267).
7. Remove the existing adaptor (see "Removing an adapter" on page 217).
8. See the documentation that comes with the adapter for any cabling instructions and information about
jumper or switch settings. (It might be easier for you to route cables before you install the adapter.)
9. Touch the static-protective package that contains the adapter to any unpainted metal surface on the
server; then, remove the adapter from the package.
224
System x3300 M4 Installation and Service Guide