Lenovo x3300 M4 7382 Installation And Service Manual page 239

7. Remove the existing RAID adaptor remote battery (see "Removing a RAID adapter remote battery or
flash power module from the server" on page 225).
8. See the documentation that comes with the adapter for any cabling instructions and information about
jumper or switch settings. It might be easier for you to route cables before you install the adapter.
9. Touch the static-protective package that contains the RAID adaptor remote battery; then, remove the
RAID adaptor remote battery from the package.
10. Install the ServeRAID adapter on the system board (see "Installing an adapter" on page 61).
11. Connect one end of the battery cable to the RAID adapter battery connector.
12. Route the remote battery cable as shown in the following illustration.
Attention: Make sure that the cable is not pinched and does not cover any connectors or obstruct any
components on the system board.
13. Install the battery:
a. Align the battery cable connector with the slot on the battery holder. Place the battery into the battery
holder and make sure that the battery holder engages the battery securely.
.
Chapter 6 Removing and replacing components
227