6. Grasp the flash device and pull to remove it from the connector.
7. Press down on the retention latch to return it to the locked position.
8. If you are instructed to return the flash device, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Installing a USB embedded hypervisor flash device
To install a hypervisor flash device, complete the following steps:
1. Read the safety information in "Safety" on page vii and "Installation guidelines" on page 25.
2. Turn off the server and peripheral devices and disconnect the power cords.
3. Remove the cover (see "Removing and installing the cover" on page 29).
4. Remove the riser-card assembly (see "Removing the riser-card assembly" on page 75).
5. Unlock the retention latch on the USB connector by squeezing the two retention clips toward each
other (see "System-board internal connectors" on page 16.
6. Align the flash device with the USB connector on the system board and push it into the USB
connector until it is firmly seated.
7. Press down on the retention latch to lock the flash device into the USB connector.
8. Install the riser-card assembly (see "Installing the riser-card assembly" on page 76).
9. Go to "Completing the installation" on page 47.
Replacing the operator information panel assembly
To replace the operator information panel assembly, use the following procedures:
Removing the operator information panel assembly
To remove the operator information panel assembly, complete the following steps.
1. Read the safety information in "Safety" on page vii and "Installation guidelines" on page 25.
Chapter 6. Replacing CRUs and FRUs
53