Panasonic FP-E Programming Manual page 1141

WR904 FP0R
Relay
No.
TOOL port
R9040 operation mode
flag
COM port PLC
R9041
link flag
R9042 Not used
R9043 Not used
COM port
SEND/RECV
R9044
instruction
execution flag
COM port
SEND/RECV
R9045 instruction
execution end
flag
R9046 Not used
R9047 Not used
R9048 Not used
R9049 Not used
R904A Not used
R904B Not used
R904C
Not used
to R904F
A: Available, N/A: Not available
Note) R9040 to R904F can be changed during 1 scan.
WR905 FP0R
Relay
Name
No.
MEWNET-W0
PLC link
R9050
transmission
error flag
R9051 to
Not used
R905F
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
Turns on when the general-purpose communication function is being
-
used
Goes off when the computer link function is being used.
-
Turn on while the PLC link function is used.
Monitors whether the F145 (SEND) or F146 (RECV) instructions can
be executed or not.
Off: None of the above mentioned instructions can be executed.
(During executing the instruction)
On: One of the above mentioned instructions can be executed.
Monitors if an abnormality has been detected during the execution of
the F145 (SEND) or F146 (RECV) instructions as follows:
Off: No abonormality detected.
On: An abnormality detected. (communication error)
End code: DT90124
When using MEWNET-W0
Turns on when a transmission error occurs at PLC link.
-
Turns on when there is an error in the PLC link area settings.
-
Description
Description
5-53