Panasonic FP-E Programming Manual page 1125

FP-e (A: Available, N/A: Not available)
Register
No.
DT9020
Not used
DT9021
Not used
Scan time (current
DT9022
value)
Scan time
DT9023 (minimum value)
Note)
Scan time
DT9024 (maximum value)
Note)
Mask condition
DT9025 monitoring register
for interrupts
DT9026 Not used
Periodical interrupt
DT9027
interval (INT24)
DT9028
Not used
DT9029
Not used
DT9030 Message 0
DT9031 Message 1
DT9032 Message 2
DT9033 Message 3
DT9034 Message 4
DT9035 Message 5
Note) Scan time display is only possible in RUN mode and shows the operation cycle time. (in PROG
mode, the scan time for the operation is not displayed.) The maximum and minimum values are
cleared each time the mode is switched from RUN to PROG.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
-
-
The current scan time is stored here. Scan time
is calculated using the formula:
Note)
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K50 indicates 5 ms.
The minimum scan time is stored here. Scan
time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K50 indicates 5 ms.
The maximum scan time is stored here. The
scan time is calculated using the formula:
Scan time (ms) = stored data (decimal) x 0.1 ms
Example: K125 indicates 12.5 ms.
The mask conditions of interrupts using the
instruction can be stored here. Monitor using
binary display.
-
The value set by the ICTL instruction is stored.
K0: periodical interrupt is not used.
K1 to K3000: 0.5ms to 1.5s or 10ms to 30s
-
-
The contents of the specified message (Data
lenght) are stored in these special data registers
when F149 (MSG) instruction is executed.
Descriptions
Read Writ
-ing -ing
N/A N/A
A N/A
N/A N/A
A N/A
N/A N/A
A N/A
5-37