Panasonic FP-E Programming Manual page 1283

FP2/FP2SH/FP3/FP10SH (A: Available, N/A: Not available)
Address
FP2/
FP3 FP2SH
FP10SH
- DT90257
- DT90258
- DT90259
- DT90260
- DT90261
- DT90262
- DT90263
Note) For MEWNET-W system, available PLC type: FP2/FP2SH/FP3/FP10SH
For MEWNET-P system, available PLC type: FP3/FP10SH
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
An Operation error program block number
Operation
is stored (higher byte) here when an
error program
No. (hold) operation error is detected.
(Available
Program block number
PLC: FP2SH/
- H1: In the first program block
FP10SH)
- H2: In the 2nd program block
The program block number for the latest
Operation
operation error is stored here each time an
error program
No. (non-hold) operation error is detected.
(Available
Program block number
PLC: FP2SH/
- H1: In the first program block
FP10SH)
- H2: In the 2nd program block
Break
The program block number where the BRK
occurrence
instruction occurred is stored here.
program
number Program block number
(Available
- H1: In the first program block
PLC: FP2SH/
- H2: In the 2nd program block
FP10SH)
Type of IC memory card is monitored here
as:
- H5: Flash-EEPROM type IC memory
card
Type of IC
- H6: SRAM type IC memory card
memory card
- H506: For FP10SH, flash-
(Available
EEPROM/SRAM mixed type IC memory
PLC: FP2SH/
card
FP10SH)
- H6: No archival information is stored
- H6: No data is written
- Other than above: ERROneous condition
(self-diagnostic error code E56)
Capacity of IC
The capacity of IC memory card is stored
memory card 1
in units of KB. If Flash-EEPROM/SRAM
(Available
mixed type IC memory card is used,
PLC: FP2SH/
SRAM capacity is stored.
FP10SH)
Capacity of IC
If Flash-EEPROM/SRAM mised type IC
memory card 2
(Available memory card is used, flash-EEPROM
PLC: FP2SH/
capacity is stored in units of KB.
FP10SH)
File register
The current value of file register bank is
bank (current
stored here.
value)
Descriptions
Read Writ-
-ing ing
A N/A
5-195