Panasonic FP-E Programming Manual page 758

High−level Instructions
The control code, initial speed, maximum speed, acceleration/deceleration time, and target value are
specified by creating the data table "S" to "S+11" on the following page using the user program.
The frequency is changed using the specified acceleration/deceleration time from the initial speed to the
maximum speed. During deceleration, the frequency is changed based on the same slope as during
acceleration.
If the frequency is set to 50 kHz or more, specify a duty of 1/4 (25%).
If the frequency for ch2 or ch3 of FP−X Tr type is set to 10kHz or more, specify a duty of 1/4 (25%).
Table of areas used
For FPΣ
Channel no. Control flag
ch0 R903A
R903C
ch2
For FP−X Ry type
Channel no. Control flag
ch0 R911C
ch1 R911D
Note) Ch1 cannot be used for C14R.
For FP−X Tr type
Channel no. Control flag
ch0 ch0 R911C R911C
ch1 ch1 R911D R911D
ch2 ch2 R911E R911E
ch3 ch3 R911F R911F
Note) There is no ch3 for C14T and C14TD.
Note) The pulse I/O cassette (AFPX−PLS) cannot be installed on the FP−X Tr type.
Note) Use the ch2 and ch3 at up to 20 kHz.
3 − 494
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Elapsed value area Target value area
DT90044, DT90045 DT90046, DT90047
DT90200, DT90201 DT90202, DT90203
Elapsed value area Target value area
DT90348, DT90349 DT90350, DT90351
DT90352, DT90353 DT90354, DT90355
Elapsed value area Target value area
DT90348
DT90349
DT90352
DT90353
DT90356
DT90357
DT90360
DT90361
DT90350
DT90351
DT90354
DT90355
DT90358
DT90359
DT90362
DT90363
FPΣ/FP−X