Panasonic FP-E Programming Manual page 1267

FP2/FP2SH/FP3/FP10SH (A: Available, N/A: Not available)
Address
FP2/
FP3 FP2SH
FP10SH
DT9022 DT90022
DT9023 DT90023
DT9024 DT90024
DT9025 DT90025
(*Note) (*Note)
DT9026
DT90026
(*Note)
DT9027
DT90027
(*Note)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
The current scan time is
stored here. Scan time is
calculated using the
Scan time formula:
(current value) Scan time (ms) = stored
data (decimal) x 0.1
Example:
K50 indicates 5 ms.
The minimum scan time
is stored here. Scan time
is calculated using the
Scan time
formula:
(minimum
Scan time (ms) = stored
value)
data (decimal) x 0.1
Example:
K50 indicates 5 ms.
The maximum scan time
is stored here. Scan time
is calculated using the
Scan time
formula:
(maximum
Scan time (ms) = stored
value)
data (decimal) x 0.1
Example:
K125 indicates 12.5 ms.
The mask conditions of interrupt unit
Mask condition
initiated interrupts using ICTL instruciton
monitoring
can be monitored here. Monitor using
register for
binary display.
interrupt unit
initiated
interrupts
(INT 0 to 15)
0: interrupt disabled (masked)
(*FP2: Not used)
1: interrupt enabled (unmasked)
The mask conditions of interrupt unit
Mask condition
initiated interrupts using ICTL instruciton
monitoring
can be monitored here. Monitor using
register for
binary display.
interrupt unit
initiated
interrupts
(INT 16 to 23)
0: interrupt disabled (masked)
(*FP2: Not used)
1: interrupt enabled (unmasked)
The value set by ICTL instruction is
Periodical stored.
interrupt K0: periodical interrupt is not used.
interval (INT24) K1 to K3000: 10ms to 30s or 0.5ms to
1.5s
Descriptions
Scan time
display is
only possible
in RUN
mode, and
shows the
operation
cycle time.
The
maximum
and
minimum
values are
cleared
when each
the mode is
switched
between
RUN mode
and PROG.
mode.
Read- Writ-
ing ing
A N/A
5-179