Panasonic FP-E Programming Manual page 1099

FP0
Add-
Item
ress
402
Input
setting
403
Note1) With the TOOL software, "0" or "1" is set for each bit on the screen in the setting for system
register 403.
Note2) If system register 400 to 403 are set simultaneously for the same inptu relay, the following
precedence order is effective:
[High-speed counter] '[Pulse catch]' [Interrupt input].
When the high-speed counter is being used in the incremental input mode, even if input X0 is
specified as an interrupt input and as pulse catch input, those settings are invalid, and input X0
functions as counter input for the high-speed counter.
No. 400: H1 a This setting will be valid.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Name
Pulse catch input
function settings
Interrupt input settings
Default
value
The checked contacts are set as
pulse catch input.
In FP Programmer II, enter the above
settings in hexadecimal.
Example:
Not set
When X3 and X4 are set as pulse
(H0)
catch input
Settings X6 and X7 are invalid.
Using FPWIN GR
The checked contacts are set as
interrupt input.
Specify the effective interrupt edge.
(When set: ON→OFF is valid)
Using FP Programmer II
Example:
Not set
When setting inputs X0, X1, X2 and
(H0)
X3 as interrupts, and X0 and X1 are
set as interrupt inputs when going
from on to off.
No. 402: H1 No. 403: H1
Descriptions
5-11