Swrite Instruction - Mitsubishi QCPU Structured Programming Manual

5.4.4

SWRITE instruction

J(P)_SWRITE
G(P)_SWRITE
Structured ladder
J_SWRITE G_SWRITE
EN ENO EN
Jn* d1 Un*
s1 d2 s1
s2 d3 s2
Input argument EN: Executing condition
Jn*: Network number of the host station (1 to 239, 254)
254: Network specified in
access
Un*: Start I/O number of the module
(00 to FE: Higher two digits when expressing the I/O number in
three digits)
s1: Variable that stores control data
s2: Start number of the host station's device that stores write data :ANY16
Output argument ENO:
Execution result
d1: Start number of the target station's device to which data are
written
d2: Variable that turns ON upon completion of the instruction
d2[1] also turns ON at the time of error completion.
d3: Variable that turns ON upon completion of the instruction
(Write notification device)
Setting
data
5.4 CC-Link IE Controller Network, MELSECNET/H, and Ethernet Instruction
ST
ENO
ENO:= (EN, Jn*, s1, s2, d1, d2, d3);
J_SWRITE
d1 ENO:= (EN, Un*, s1, s2, d1, d2, d3);
G_SWRITE
d2
d3
"
Valid module during other station
"
Internal device
R, ZR
*1
Bit Word
−
S1
−
S2
−
d1
d2
d3
*1: Local devices and file registers per program cannot be used as setting data.
J_SWRITE, G_SWRITE
J_SWRITE, G_SWRITE
P: Executing condition
indicates any of the following
instructions.
J_SWRITE
G_SWRITE
:Bit
:ANY16
:ANY16
:Array of ANY16 [0..17]
:Bit
:ANY16
:Array of bit [0..1]
:Bit
J \
U \G
Bit Word
−
−
−
−
−
5.4.4 SWRITE instruction
:
JP_SWRITE
GP_SWRITE
5
Zn Constant Others
5-107