Rlpaset Instruction - Mitsubishi QCPU Structured Programming Manual

G_RLPASET
5.3.7

RLPASET instruction

G(P)_RLPASET
Structured ladder
G_RLPASET
EN ENO
Un*
s1
s2
s3
s4
s5
Input argument EN:
Un*:
s1:
s2:
s3:
s4:
s5:
Output argument ENO:
d:
Function
This instruction sets the network parameters to the master station and starts up the data link.
5.3 CC-Link Instruction
5-92
5.3.7 RLPASET instruction
ST
d
ENO:= (EN, Un*, s1, s2, s3, s4, s5, d);
G_RLPASET
Executing condition
Start I/O number of the module
(00 to FE: Higher two digits when expressing the I/O number in
three digits)
Variable that stores control data
Variable that stores slave station setting data
Variable that stores reserved station specification data
Variable that stores error invalid station specification data
Variable that stores send/receive and auto-refresh buffer
assignment data
Execution result
Variable that turns ON upon completion of the instruction
d[1] also turns ON at the time of error completion.
Internal device
Setting
*1
data
Bit Word
−
S1
−
S2
−
S3
−
S4
−
S5
d
P: Executing condition
instructions.
G_RLPASET
GP_RLPASET
:Bit
:ANY16
:Array of ANY16 [0..7]
:Array of ANY16 [0..63]
:Array of ANY16 [0..3]
:Array of ANY16 [0..3]
:Array of ANY16 [0..7]
:Bit
:Array of bit [0..1]
J \
R, ZR
U
Bit Word
*1: Local devices and file registers per program cannot be used as setting data.
G_RLPASET
:
indicates any of the following
Zn Constant Others
\G
−
−
−
−
−
−