Gete Instruction - Mitsubishi QCPU Structured Programming Manual

5.2.13

GETE instruction

GP_GETE
Structured ladder
G_GETE
EN ENO
Un* d
s1
s2
Input argument EN: Executing condition
Un*: Start I/O number of the module
(00 to FE: Higher two digits when expressing the I/O number in
three digits)
s1: Variable that stores control data
s2:
Start number the device that stores the read registration data :ANY16
Output argument ENO: Execution result
d: Variable that turns ON upon completion of the instruction
d[1] also turns ON at the time of error completion.
Setting
data
Function
This instruction reads a user frame.
ST
ENO:= (EN, Un*, s1, s2, d);
G_GETE
Internal device
R, ZR
*1
Bit Word
−
S1
−
S2
d d
*1: Local devices and file registers per program cannot be used as setting data.
5.2 Serial Communication and Modem Interface Instruction
P: Executing condition
indicates any of the following
instructions.
G_GETE
GP_GETE
:Bit
:ANY16
:Array of ANY16 [0..3]
:Bit
:Array of bit [0..1]
J \
U \G
Bit Word
−
−
−
5.2.13 GETE instruction
G_GETE
G_GETE
:
5
Zn Constant Others
5-75