ACX2200 Universal Access Router Hardware Guide
Related
Documentation
ACX2200 Routers Hardware and CLI Terminology Mapping
4
The ACX2200 router is a compact gateway router that is one rack unit (U; that is, 1.75 in.,
or 4.45 cm) tall. Several gateway routers can be stacked in a single floor-to-ceiling rack
for increased port density per unit of floor space.
The chassis is a rigid sheet metal structure that houses all the other router components
(see
Figure 1 on page 4
and
high, 9.4 in. (24 cm) deep, and 17.5 in. (44.5 cm) wide. The outer edges of the mounting
brackets extend the width to 19 in. (48 cm) (from the front-mounting brackets to the
rear of the chassis). The chassis installs in standard 11.81-in. (300-mm) deep (or larger)
enclosed cabinets, 19-in. equipment racks, or telco open-frame racks.
The compact routers are 1 U tall. Several routers can be stacked in a single floor-to-ceiling
rack for increased port density per unit of floor space.
The ACX2200 routers contain four Gigabit Ethernet RJ-45 ports, four Gigabit Ethernet
combination ports (either Gigabit Ethernet RJ-45 ports or Gigabit Ethernet SFP ports),
two Gigabit Ethernet SFP ports, and two 10-Gigabit Ethernet SFP+ ports. Use only one
set of these combination ports (labeled
Figure 1: Front Panel of the ACX2200 Router
Figure 2: Rear View of the ACX2200 Router
ACX2200 Routers Hardware and CLI Terminology Mapping on page 4
Front Panel of an ACX2200 Router on page 13
Table 3 on page 5
describes the hardware terms used in ACX2200 router documentation
and the corresponding terms used in the Junos OS command line interface (CLI).
Figure 3 on page 6
shows the port locations of the interfaces.
Figure 2 on page
4). The chassis measures 1.75 in. (4.45 cm)
COMBO PORTS
) at a time.
Copyright © 2017, Juniper Networks, Inc.