Figure 19: Connecting Dc Power To The Router - Juniper ACX2200 Hardware Manual

ACX2200 Universal Access Router Hardware Guide
Related
Documentation
78
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
7.
the strap to an approved site ESD grounding point. See the instructions for your site.
Connect each DC power cable to the appropriate external DC power source.
8.
NOTE: For information about connecting to external DC power sources,
see the instructions for your site.
Switch on the external circuit breakers to provide voltage to the DC power source
9.
cable leads. Observe the system LED on front of the router. If the DC power cable is
correctly installed and functioning normally, the system LED lights green steadily. If
the system LED indicates that the power supply is not functioning normally, repeat
the installation and cabling procedures.

Figure 19: Connecting DC Power to the Router

ACX2200 Power Overview on page 25
Installing and Connecting an ACX2200 Router Overview on page 63
ACX2200 DC Power Specifications on page 45
Connecting the ACX2200 Router to Earth Ground on page 73
Copyright © 2017, Juniper Networks, Inc.