Calculating Power Budget And Power Margin For Fiber-Optic Cables; Calculating Power Budget For Fiber-Optic Cable; Calculating Power Margin For Fiber-Optic Cable - Juniper ACX2200 Hardware Manual

ACX2200 Universal Access Router Hardware Guide

Calculating Power Budget and Power Margin for Fiber-Optic Cables

Calculating Power Budget for Fiber-Optic Cable

Calculating Power Margin for Fiber-Optic Cable

50
Use the information in this topic and the specifications for your optical interface to
calculate the power budget and power margin for fiber-optic cables.
TIP: You can use the
the pluggable transceivers supported on your Juniper Networks device.
To calculate the power budget and power margin, perform the following tasks:
Calculating Power Budget for Fiber-Optic Cable on page 50
1.
Calculating Power Margin for Fiber-Optic Cable on page 50
2.
To ensure that fiber-optic connections have sufficient power for correct operation, you
need to calculate the link's power budget, which is the maximum amount of power it
can transmit. When you calculate the power budget, you use a worst-case analysis to
provide a margin of error, even though all the parts of an actual system do not operate
at the worst-case levels. To calculate the worst-case estimate of power budget (P
you assume minimum transmitter power (P
P = P – P
B T R
The following hypothetical power budget equation uses values measured in decibels
(dB) and decibels referred to one milliwatt (dBm):
P = P – P
B T R
P = –15 dBm – (–28 dBm)
B
P = 13 dB
B
After calculating a link's power budget, you can calculate the power margin (P
represents the amount of power available after subtracting attenuation or link loss (LL)
from the power budget (P
P = P – LL
M B
P greater than zero indicates that the power budget is sufficient to operate the receiver.
M
Factors that can cause link loss include higher-order mode losses, modal and chromatic
dispersion, connectors, splices, and fiber attenuation.
estimated amount of loss for the factors used in the following sample calculations. For
information about the actual amount of signal loss caused by equipment and other
factors, refer to vendor documentation.
Hardware Compatibility Tool
) and minimum receiver sensitivity (P
T
). A worst-case estimate of P
B
to find information about
), which
M
assumes maximum LL:
M
Table 23 on page 51 lists an
Copyright © 2017, Juniper Networks, Inc.
),
B
):
R