Minolta Di200 Service Manual page 22

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
Symbol Part Name
PWB-A Master Board
PWB-F Panel Board
PWB-H Double Feed
Detecting Board ( )
PWB-I Paper Size
Detecting Board
PWB-M ROM/RAM Board
PWB-N Network ROM Board
PWB-R Fuser Frame
Register Board
PWB-R2 Pre-Transfer Guide Plate
Register Board 1
PWB-R2 Pre-Transfer Guide Plate
Register Board 2
BCR BCR Board
MFB2 MFB2 Board
CCD2 CCD2 Board
INV Inverter Board 1
PU1 Power Supply Unit
PU2 High Voltage Unit
PU3 Inverter Board 2
UN1 Touch Panel
: Only on the 35-cpm copier
Removal Procedure
Remove the Rear Upper Cover. → Remove the Upper Rear Cover.
→ Remove the Shield Box. → Remove the MFB2 Board Assy. →
PWB-A
For details, see steps 2 through 12 of "(1) Removal of the PH
Unit" of "2-5. OPTICAL SECTION."
Remove the Front Cover. → Remove the Front Holding Bracket. →
Remove the Left Front Upper Cover. → Remove the Upper Front
Cover. → Remove six screws and the Control Panel. → PWB-F
Slide out the Multi Purpose Cassette. → Remove one screw and the
PWB-H Mounting Bracket. → PWB-H
Remove the Harness Cover. → Remove the Rear Cover. → Unhook
two tabs and remove the PWB Cover. → PWB-I
Remove the Rear Upper Cover. → Remove the Upper Rear Cover.
→ Remove the Shield Box. → Remove PWB-M and PWB-N at the
same time. → PWB-M
Remove the Rear Upper Cover. → Remove the Upper Rear Cover.
→ Remove the Shield Box. → Remove PWB-M and PWB-N at the
same time. → PWB-N
Remove the Fusing Unit. → PWB-R
Open the Side Cover and remove the Vertical Transport Unit. →
PWB-R2
Open the Side Cover. → Remove the I/C. → Remove one screw
and the PWB Cover. → PWB-R2
Remove the Left Rear IR Cover. → Remove three screws and the
Harness Cover. → BCR
Remove the Rear Upper Cover. → Remove the Upper Rear Cover.
→ Remove the Shield Box. → Remove PWB-M and PWB-N. →
MFB2
For details, see steps 2 through 9 of "(1) Removal of the PH Unit"
of "2-5. OPTICAL SECTION."
D-16
Remove the Original Glass. → INV
Remove the Upper Cover. → Remove the Front Cover. → Remove
the Left Cover. → Remove the Reinforcement Bracket. → Remove
three screws and the PU1 Mounting Bracket Assy. → PU1
Open the Side Cover. → Remove the I/C. Remove two screws and
the High Voltage Unit Cover. → PU2
Remove the Front Cover. → Remove the Upper Front Cover. →
Remove the Front Holding Bracket. → Remove the Left Front Upper
Cover. → Remove six screws and the Control Panel. → PU3
Remove the Front Cover. → Remove the Upper Front Cover. →
Remove the Front Holding Bracket. → Remove the Left Front Upper
Cover. → Remove six screws and the Control Panel. → UN1
D-7