Minolta Di200 Service Manual page 37

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
Cable on Hook End
1167D054AD
Cable on
Bead End
1167D055AD
4011D051AA
pulley H
pulley G
4011D052AC
pulley E
pulley F
4011D103AA
10. Wind the hook end of the cable two turns coun-
terclockwise from the front to the rear.
11. Wind the bead end of the cable four turns clock-
wise from the rear to the front. Then, secure the
cable with tape.
NOTE
• Make sure that no part of the cable rides on the
other.
12. Slide the pulley toward the rear and fit one retain-
ing ring E type.
13. Pushing the pulley tightly up against the retaining
ring E type, secure the pulley with one screw.
14. Wind the fixed bead end of the cable around pul-
ley H and pulley G and fit the fixed bead at a
position about 5.5 mm from the Scanner rail.
15. Wind the hook end of the cable around pulley E
and pulley F.
D-22