Minolta Di200 Service Manual page 55

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
<Right/Left>
Requirement
1171D005AA
1171D005AA
NOTE
• This adjustment must be made when the PH Unit has been replaced and after Registra-
tion (CD) (Printer) have been made.
Adjustment Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch "Tech. Rep. Choice" and "Printer", in that order.
3. Touch "Edge Erase" and "Right/Left" in that order to call up the Right/Left Edge Erase
adjustment function.
4. Press the Clear key to clear the current setting value.
5. Enter the new setting value from the 10-Key Pad.
Setting Instructions
To make the edge erase width (width A) smaller, decrease the setting value.
To make the edge erase width (width A) greater, increase the setting value.
4011D299CA
6. Touch "END" to validate the setting value.
NOTE
• Be sure to touch "END" to return to the normal operating mode. If the Panel Reset key is
used, the previous setting remains valid.
Set the erase width on the right and left edges of
paper (width A) in the range between 0 and 5 mm.
A
Adjust Mode
Edge Erase/Right/Left
A
Setting Value
D-40
Setting Range
0 to 5
Use to clear
setting value.
Use to enter setting value.
1167D069AA