Minolta Di200 Service Manual page 19

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
No. Part Name
Remove no. 17. → Remove two holding brackets.
1 Original Glass
2 Right IR Cover Remove two screws that secure the Right IR Cover.
3 Upper Rear Unhook one tab and remove the Upper Rear Inside Cover.
Inside Cover
Remove no. 13. → Remove no. 3. → Remove the MFB2 Board. → Remove
4 Lower Rear
the PWB-A Board Assy. → Open the Manual Bypass Tray. → Open the Exit
Inside Cover
Cover of no. 5. → Remove three screws that secure the Rear Inside Cover.
For removal of the MFB2 Board Assy and PWB-A Board Assy, see steps 2
through 11 of "(1) Removal of the PH Unit" of "2-5. OPTICAL SECTION."
5 Fusing Unit
D-27
Remove no. 11. → Remove no. 5. → Remove two screws that secure the
6 Front Inside
Cover Front Inside Cover.
Open the Toner Bottle Cover. → Unhook the dowels at four places of the
7 Toner Bottle
Cover Toner Bottle Cover and remove the cover.
Remove no. 28. → Remove two connectors. → Remove two screws that
8
Duplex Unit ( 2)
secure the Duplex Unit.
9 Side Cover —
Remove no. 28. → Unplug one connector. → Remove three screws that
10 Manual Bypass
Tray secure the Manual Bypass Tray.
Open the Side Cover. → Slide the Side Cover to the front and, at the same
11 Fixed Paper Size
Cassette Side time, pull the rear side out of the frame.
Cover ( 1)
Slide out no. 12. → Remove three screws that secure the Front Cover.
12 Front Cover
Slide out the Multi Purpose Cassette. → Pushing the tab on the right rail, pull
13 Multi Purpose
Cassette out the cassette.
Slide out the Fixed Paper Size Cassette. → Pushing the tabs on both the
14 Fixed Paper Size
right and left rails, pull out the cassette.
Cassette ( 1)
15 Upper Cover Remove two screws that secure the Upper Cover.
Remove no. 11. → Remove no. 17. → Remove no. 16. → Remove no. 15.
16 Control Panel
→ Remove five screws that secure the Control Panel.
Remove no. 11. → Remove no. 17. → Remove no. 16. → Remove six
17 Upper Front
Cover screws that secure the Upper Front Cover.
Remove no. 17. → Remove two screws that secure the Left Front Upper
18 Left Front Upper
Cover Cover.
Remove two screw caps. → Remove two screws that secure the Front Hold-
19 Front Holding
Bracket ing Bracket.
Remove no. 17. → Remove two screws that secure the Upper Left Cover.
20 Upper Left Cover
21 Left Hinge Cover Remove one screw that secures the Hinge Cover.
Remove nos. 19 and 21. → Remove two screws that secure the Rear Hold-
22 Rear Holding
Bracket ing Bracket.
23 Right Hinge Remove one screw that secures the Hinge Cover.
Cover
24 Original Cover Pull the Original Cover straight upward.
25 Left IR Cover Remove two screws that secure the Left IR Cover.
26 Left Rear IR Remove one screw that secure the Left Rear IR Cover.
Cover
Remove the Fusing Unit. → Remove no. 4. → Unhook the two tabs of the
27 Exit Lower Cover
Exit Lower Cover and remove the cover.
28 Left Cover Remove four screws that secure the Left Cover.
Removal Procedure
D-4