Book Center Erase - Minolta Di200 Service Manual

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09

(10) Book Center Erase

Requirement
A
4011D083AB
NOTES
• This setting determines the erase width when Book Center Erase is selected.
• This adjustment must be made when a shadow is produced at the center of the copy
made from an open book.
Adjustment Procedure
1. Call the Tech. Rep. Mode to the screen.
2. Touch "Tech. Rep. Choice".
3. Touch "Book Center Erase" to call up the Book Center Erase adjustment function.
4. Press the Clear key to clear the current setting value.
5. Enter the new setting value from the 10-Key Pad.
Setting Instructions
To make the erase width at the center of the paper (width A) smaller, decrease the setting
value.
To make the erase width at the center of the paper (width A) greater, increase the setting
value.
Setting Value
6. Touch "END" to validate the setting value.
NOTE
• Be sure to touch "END" to return to the normal operating mode. If the Panel Reset key is
used, the previous setting remains valid.
Set the erase width at the center of the paper (width
A) in the range between 2 and 20 mm.
Adjust Mode
Book Center Erase
4011P302CA
D-54
Setting Range
2 to 20
Use to clear
setting value.
Use to enter setting value.
1167D069AA