Minolta Di200 Service Manual page 59

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
8. Enter the new setting value from the 10-Key Pad.
Use the Access Mode key or " " to change the + or - sign.
Setting Instructions
If width A is wider than specifications, make the setting value smaller than the current one.
If width A is narrower than specifications, make the setting value greater than the current
one.
If a single adjustment procedure does not successfully bring width A into the specified
range, try another setting value.
Setting Value
9. Touch "END" to validate the setting value.
NOTE
• Be sure to touch "END" to return to the normal operating mode. If the Panel Reset key is
used, the previous setting remains valid.
Checking for Each Paper Source
• 1-Sided: In step 3, touch "Test Print", select the paper source, then press the Start key.
• 2-Sided: In step 3, touch "Test Print", select the paper source and "Duplex", then press
the Start key.
Use to change the + or- sign.
4011P258CA
D-44
Use to change
the + or- sign.
Use to clear
setting value.
Use to enter setting value.
4011D001AA