Minolta Di200 Service Manual page 57

FrameMaker Ver.5.5E(PC) Di200/Di251/Di351 DIS/REASSEMBLY, ADJUSTMENT
01.02.09
9. Enter the new setting value from the 10-Key Pad.
Use the Access Mode key or " " to change the + or - sign.
Setting Instructions
If width A is wider than specifications, make the setting value smaller than the current one.
If width A is narrower than specifications, make the setting value greater than the current
one.
If a single adjustment procedure does not successfully bring width A into the specified
range, try another setting value.
4011P257CA
Setting Value
10. Touch "END" to validate the setting value.
NOTE
• Be sure to touch "END" to return to the normal operating mode. If the Panel Reset key is
used, the previous setting remains valid.
11. Perform the same steps to adjust for other paper sources.
Checking for 2-Sided for Each Paper Source
• In step 3, touch "Test Print", select the paper source and "Duplex", and then press the
Start key.
Use to enter setting value.
Use to change the + or- sign.
D-42
Use to change
the + or- sign.
Use to clear
setting value.
4011D001AA