Alcatel-Lucent 5620 Troubleshooting Manual page 139

Release 12.0 R4 | August 2014 | 3HE 08864 AAAD TQZZA Edition 01
•
•
4 Click on the Command Line tab to configure the LogViewer CLI application.
5 Configure the following parameter:
•
6 Choose an ANSI display attribute from the drop-down menu beside each of the
following parameters to specify how the CLI application displays the
corresponding text.
•
•
•
•
•
•
•
•
7 Configure the Always Use ANSI Display parameter, as required.
8 Click on the 5620 SAM tab to configure the parameters that are specific to the
5620 SAM.
Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
Troubleshooting Guide
Enable Viewer Performance Stats—Select this parameter to enable the display
of LogViewer performance statistics.
Stats Timer (seconds)—Enter a value to specify the number of seconds that
LogViewer waits between log statistics updates.
Command line buffer size—Enter a value to specify the number of log messages
that LogViewer buffers when the CLI application is in command mode.
Normal Display—for normal application text
Trace Level Display—for trace-level log entries
Debug Level Display—for debug-level log entries
Info Level Display—for info-level log entries
Warning Level Display—for warning-level log entries
Error Level Display—for error-level log entries
Fatal Level Display—for fatal-level log entries
Filter Display—for filtered log entries
11 — Troubleshooting with the 5620 SAM LogViewer
11-13