Mitsubishi Q01CPU User Manual page 260

10
LOADING AND INSTALLATION
Square washer
Mounting screws
10
- 16 10.3 Module Installation
10.3.1 Precaution on installation
<For Q35B, Q65B, Q00JCPU, Q33B, Q52B, Q55B, Q63B, Q32SB, Q33SB or
Q35SB type>
Screw the DIN rail in two places using the mounting screws and square washers
included with the adaptors in 'Position A' (bottom of base unit).
B *3
Mounting screws
(included with adaptors)
DIN rail
Square washers necessary *1
35mm
Stopper
Diagram 10.12 DIN rail mounting screw intervals
* 1
DIN rail
(M5 10)
Side view A
Diagram 10.13 Square washer
* 2: Screw the DIN rail to a control panel using the mounting screws and square washers included
with the adaptors in 'Position A' (bottom of base unit).
* 3: Screw the DIN rail with mounting screws(obtained by user) in 'Position B' (Where the base unit is
not installed). In this method the supplied mounting screws and square washers are not used.
POINT
(1) Use only one washer for each mounting screw. Use only the square washers
supplied with the adaptors.
If two or more washers are used together for one mounting screw, the screw
may interfere with the base unit.
(2) Make sure to align the square washer sides with the DIN rail.
square washer
Diagram 10.14 Precautions when mounting a square washer
(3) Use the DIN rail that is compatible with M5 size screws.
A *2
Mounting screws (obtained by user)
No square washers
Stopper
P P
square washer
DIN rail
B *3
P
P=200mm (7.88 inch) or less
Mounting screws DIN rail
Mounting side
(e.g. Control panel)
Side view A
square washer DIN rail