Part Names - Mitsubishi Q01CPU User Manual

6
BASE UNIT AND EXTENSION CABLE

6.1.2 Part Names

The names of the parts of the base unit are described below.
(1) Main base unit (Q33B, Q35B, Q38B, Q312B)
5)
1)
OUT
5V
SG
2)
POWER
FG
No. Name
1) Extension cable connector
2) Base cover
3) Module connector
4) Module fixing screw hole
5) Base mounting hole
6) DIN rail adapter mounting hole Hole for mounting DIN rail adapter
6
- 6 6.1 Base Unit
6.1.2 Part Names
4)
CPU I/O0 I/O1 I/O2 I/O3
Diagram 6.1 Main base unit (Q33B, Q35B, Q38B, Q312B)
Table6.9 Part Names
Connector for connecting an extension cable (for signal communications with the
extension base unit)
Protective cover of extension cable connector. Before an extension cable is
connected, the area of the base cover surrounded by the groove under the word
"OUT" on the base cover must be removed with a tool such as nippers.
Connector for installing the Q series power supply module, CPU module, I/O
modules, and intelligent function module.
To the connectors located in the spare space where these modules are not installed,
attach the supplied connector cover or the blank cover module (QG60) to prevent
entry of dirt.
Screw hole for fixing the module to the base unit. Screw size: M3 12
Hole for mounting this base unit onto the panel of the control panel (for M4 screw)
I/O4 IO5 I/O6 I/O7 I/O8
3)
Application
I/O9 I/O10 I/O11
6)