Agilent Technologies 1260 Infinity II User Manual page 242

13
LAN Configuration
Manual Configuration
Table 21
Value
?
/
ip <x.x.x.x>
sm <x.x.x.x>
gw <x.x.x.x>
exit
4 To change a parameter follows the style:
5 Use the "/" and press Enter to list the current settings.
Figure 42 Telnet - Current settings in "Using Stored" mode
242
Telnet Commands
•
parameter value, for example:
ip 134.40.28.56
Then press [Enter], where parameter refers to the configuration parameter
you are defining, and value refers to the definitions you are assigning to
that parameter. Each parameter entry is followed by a carriage return.
Description
displays syntax and descriptions of commands
displays current LAN settings
sets new ip address
sets new subnet mask
sets new default gateway
exits shell and saves all changes
information about the LAN interface
MAC address, initialization mode
Initialization mode is Using Stored
active TCP/IP settings
TCP/IP status - here ready
connected to PC with controller software (e.g. Agilent
ChemStation), here not connected
Agilent 1260 Infinity II Preparative Autosampler User Manual