Table 20
SW 6
ON
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. OpenLAB CDS ChemStation Edition,
Agilent 1260 Infinity II Preparative Autosampler User Manual
LC Modules with 8-bit configuration switch (B-firmware) (configuration switch
at rear of the instrument)
SW 7
SW 8
OFF
OFF
Lab Advisor, Firmware Update Tool) and use MAC address as host name,
e.g. 0030d3177321.
The LC system should become visible in the control software (see Note in
section
"General Information (DHCP)"
Dynamic Host Configuration Protocol (DHCP)
Initialization Mode
DHCP
on page 237).
13
LAN Configuration
239