Initialization Mode Selection - Agilent Technologies 1260 Infinity II User Manual

Initialization Mode Selection

The following initialization (init) modes are selectable:
Table 17
Default IP address for LAN is 192.168.254.11.
DHCP address is the module's LAN MAC address.
Using Stored
When initialization mode Using Stored is selected, the parameters are taken
from the non-volatile memory of the module. The TCP/IP connection will be
established using these parameters. The parameters were configured
previously by one of the described methods.
Figure 34
Agilent 1260 Infinity II Preparative Autosampler User Manual
Initialization Mode Switches
SW1 SW2
0 0
0 0
0 0
Note: The setting '0' (down) is essential.
Using Stored (Principle)

Initialization Mode Selection

SW3 SW4 SW5 SW6
0 0 0 0
0 0 1 0
0 1 0 0
13
LAN Configuration
Init Mode
Use Default IP
Address
Use Stored IP Address
Use DHCP
235