Dhcp Radio Buttons; Subnet Mask Field; Mac Address Field - Extron electronics FOX Matrix 3200 User Manual

DHCP radio buttons

The radio button directs the switcher to ignore any entered IP addresses and to
DHCP On
obtain its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the
network is DHCP capable). The
system administrator to determine if DHCP is appropriate.
IP Address field
The field contains the IP address of the connected switcher. This value is
IP Address
encoded in the flash memory of the switcher.
Valid IP addresses consist of four 1‑, 2‑, or 3‑digit numeric octets separated by dots
(periods). Each field can be numbered from 000 through 255. Leading zeroes, up to 3 digits
total per field, are optional. Values of 256 and above are invalid.
The factory‑installed default address is 192.168.254.254, but if this conflicts with other
equipment at your installation, you should ask your network administrator for a new, valid
address.
NOTE: IP address changes can cause conflicts with other equipment. Only local system
administrators should change IP addresses.
Gateway IP Address field
The field identifies the address of the gateway to the mail server to be
Gateway IP Address
used if the switcher and the mail server are not on the same subnet.
The gateway IP address has the same validity rules as the system IP address.

Subnet Mask field

The field is used to determine whether the switcher is on the same subnet
Subnet Mask
as the mail server when you are subnetting. For more information, see
on page 122.
Primer

MAC Address field

The Media Access Control (MAC) address is hardcoded in the switcher and cannot be
changed.
Firmware field
The field identifies the installed firmware version. This field is hardcoded in the
Firmware
switcher and cannot be changed.
Model field
The field identifies the number of inputs and outputs. This field is hardcoded in the
Model
switcher and cannot be changed.
Part Number field
The field identifies the part number of your switcher. This field is hardcoded in
Part Number
the switcher and cannot be changed.
radio button turns DHCP off. Contact the local
DHCP Off
FOX Matrix 3200 and 7200 Switchers • HTML Operation
Subnetting — A
98