Turn Signal Control Lever - Suzuki NEXA FRONX Owner's Manual & Service Booklet

To cancel the function:
Perform any of the following operations.
• Pull the lighting control lever toward you
once.
• Turn the ignition switch to "ACC" or "ON"
position or change the ignition mode to
ACC or ON by pressing the engine
switch.
• Turn the lighting switch to any other
position than "AUTO" position.
NOTE:
• When the "To home" is functioning, the
front fog lights (if equipped), rear fog
light (if equipped) and the headlights
(high beam) are not turned on.
• Lighting time of the "To home" function
can be changed on the information dis-
play. Refer to "Information display" in
"INSTRUMENT CLUSTER" section.
"To car" function
Before you get in the vehicle, the ground
will be illuminated for a short while to easily
lead the driver to the vehicle. If UNLOCK
button of the keyless push start system
remote controller is pressed while the light-
ing switch is positioned in "AUTO", the
front position lights and the headlights in
the low beam are turned on for 10 sec-
onds.
This function will operate only when it is
dark outside the vehicle.
To cancel the function:
Perform any of the following operations.
• Lock the doors by using the keyless
push start system remote controller, the
request switch or the key in the driver's
door lock.
• Change the ignition mode to ACC or ON
by pressing the engine switch.
• Turn the ignition switch to ACC or ON
position or the engine switch is pressed
to change the ignition mode to ACC or
ON.
• Turn the knob at the end of the lighting
control lever to any other position than
AUTO position.
NOTE:
• When the "To car" is functioning, the
front fog lights (if equipped), rear fog
light (if equipped) and the headlights
(high beam) are not turned on.
• Lighting time of the "To car" function can
be changed on the information display.
Refer to "Information display"
"INSTRUMENT CLUSTER" section.
BEFORE DRIVING

Turn Signal Control Lever

You can use the turn signal control lever
when the ignition switch in "ON" position or
the ignition mode ON.
Turn Signal Operation
With the ignition switch in "ON" position or
the ignition mode ON, move the lever
upward or downward to activate the left or
right turn signals.
Turning left
(a) (a)
Turning right
in
• Move the turn signal control lever (1) as
follows:
– Turning left: Move the lever upward.
– Turning right: Move the lever down-
ward
• When you move the lever, the turn signal
lights as well as the turn signal light indi-
cators on the instrument cluster will flash
simultaneously.
• When you move the lever to its original
position, the turn signal lights as well as
( (1) (1)
(b) (b)
55TB303
3-24
55TH0-74E