Green-Mode Energy-Detect - Dell N1100-ON Reference Manual

green-mode eee
description
green-mode eee-lpi-history

green-mode energy-detect

This command enables a Dell EMC proprietary mode of power reduction on
ports that are not connected to another interface. Use the green-mode
energy-detect command in Interface Configuration mode to enable energy-
detect mode on an interface or all the interfaces. Energy-detect mode is
enabled by default on 1G copper interfaces and enabled by default on 10G
copper interfaces.
On combo ports, it is possible to configure energy-detect mode even if the
fiber port is enabled. If enabled, energy-detect mode will become active when
the copper port is used.
Use the no form of the command to disable energy-detect mode on the
interface(s).
Syntax
green-mode energy-detect
no green-mode energy-detect
Default Configuration
On N1100-ON, N1500, N2000, N2100-ON, N3000, and N3100-ON switches,
energy-detect is enabled by default. Energy detect mode is enabled by default
and cannot be disabled on N4000 10G copper interfaces.
Command Mode
Interface Configuration mode
User Guidelines
This command is available in Ethernet interface configuration mode. Cable
diagnostics (show copper-ports tdr command) may give misleading results if
green mode is enabled on the port. Disable green mode prior to running any
cable diagnostics. EEE and energy-detect modes are only supported on N4000
show green-mode
show green-mode eee-lpi-history interface
–
Layer 2 Switching Commands
441