Table of Contents
Advertisement
Syntax
bgp aggregate-different-meds
no bgp aggregate-different-meds
Default Configuration
By default, all the routes aggregated by a given aggregate address must have
the same MED value.
Command Mode
BGP Router Configuration mode
User Guidelines
When this command is used, the path for an active aggregate address is
advertised without an MED attribute and the MED attribute is not
considered in aggregating routes. When this command is not used, if
multiple routes match an aggregate address, but have different MEDs, the
aggregate takes the MED of the first matching route and any other matching
prefix with the same MED is included in the aggregate. Matching prefixes
with different MEDs are not considered part of the aggregate and continue to
be advertised as individual routes.
Command History
Introduced in version 6.2.0.1 firmware.
Example
console(config-router)#bgp aggregate-different-meds
bgp aggregate-different-meds (IPv6 Address
Family Configuration)
Use the bgp aggregate-different-meds command to allow IPv6 routes with
different MEDs to be aggregated.
Syntax
bgp aggregate-different-meds
1223
Layer 3 Routing Commands
Advertisement
Table of Contents
