Conform-Color - Dell N1100-ON Reference Manual

Examples
The following example sets the class of service trust mode of all interfaces to
trust 802.1p packet markings.
console(config)#classofservice trust dot1p
The following example displays how to set the class of service trust mode of
all interfaces to trust IP DSCP packet markings.
console(config)#classofservice trust ip-dscp

conform-color

Use the conform-color command in Policy-Class-Map Configuration mode
to enable color-aware marking for a policy.
This command is not available on the N1500 Series switches.
NOTE:
Syntax
conform-color {class-map-name} [exceed-color { class-map-name } ]
Default Configuration
This command has no default configuration.
Command Mode
Policy-Class-Map Configuration mode
User Guidelines
This command must be preceded by a police command. If the conform-color
command is not entered, the police algorithm uses the color-blind version,
meaning in the incoming color is ignored. The conform-color command can
be used with any of the three police algorithms. In the simple algorithm, only
the conform color class can be configured. The conform color class pre-colors
packets as green prior to metering. Non-conforming packets are pre-colored
red prior to metering. With the single-rate and two-rate police algorithm, the
conform color class pre-colors packets as green and the exceed color class pre-
colors packets as yellow. Non-conforming packets are pre-colored red. Per-
colored packets are then metered and re-colored based upon the meter
parameters.
670
Layer 2 Switching Commands