Table of Contents
Advertisement
Default Hold Time ............................. 90
Number of Network Entries ..................... 0
Number of AS Paths ............................ 0
Dynamic Neighbors Current/High/Limit .......... 1/1/20
Default Metric ................................ Not Configured
Default Route Advertise ....................... No
Redistributing:
Source
Metric
--------- ---------- -------------------------------- ----------------------
Neighbor
---------------- ----- -------- -------- ------------- -------------- ------
fe80::21e:c9ff:fede:b13a%Vl10
show bgp ipv6 update-group
Use this command to report the status of IPv6 outbound groups and their
members. Output and format are the same as for show ip bgp update-group.
This command deprecates and replaces the show ipv6 bgp update-group
command.
Syntax
show bgp ipv6 update-group [ group-index | ipv4-address | ipv6-address [
interface interface-id ] | autodetect interface interface-id ]
•
group-index—If specified, this option restricts the output to a single
update group.
•
ipv4-address—The IPv4 address of a peer enabled for exchange of IPv6
prefixes. If specified, this option restricts the output to the update group
containing the peer with the given address.
ipv6-address [ interface interface-id ]—The IPv6 address of a peer. If the
•
peer address is a link local address, the interface that defines the scope of
the address must also be given. If a peer address is specified, this option
restricts the output to the update group containing the peer with the given
address.
•
autodetect interface interface-id—(Optional) The routing interface on
which the neighbor's link local IPv6 address is auto detected. The
interface-id must be a VLAN routing interface.
Dist List
ASN
MsgRcvd
MsgSent
65000 137
State
136
ESTABLISHED
Layer 3 Routing Commands
Route Map
Up/Down Time
Pfx Rcvd
0
1339
Advertisement
Table of Contents
