Dot1As Timeout Sync - Dell N1100-ON Reference Manual

Initial Announce Interval...................... 0
Current Announce Interval...................... 0
Sync Receipt Timeout........................... 3
Announce Receipt Timeout....................... 5

dot1as timeout sync

Use this command to configure the number of sync intervals expiries with no
received announce message in which case the master is considered to be no
longer transmitting. Use the no form of the command to return the sync-
expiries to the default.
Syntax
dot1as timeout sync expiries
no dot1as timeout announce
Default Configuration
By default, the number of expiries is set to 3.
Command Mode
Interface Configuration
User Guidelines
IEEE 802.1AS must also be enabled globally as well as on an interface to
become operational.
Command History
Introduced in version 6.2.0.1 firmware.
Example
This example configures interface Gi1/0/4 to delay expiring the master clock,
if found, for up to 5 sync intervals.
console(config-if-Gi1/0/4)#dot1as timeout sync 5
console(config-if-Gi1/0/4)#show dot1as interface gi1/0/4
AS Interface Admin Mode................... Enabled
AS Capable................................ No
1119
Audio Visual Bridging Commands