•
priority priority-value — Priority for the rule. (Range: 1 – 64)
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with gigabitethernet, tengigabitethernet, fortygigabitethernet, vlan,
and port-channel parameters are valid only if an IP address is defined on the
appropriate interface.
Examples
The following example shows how to configure two management interfaces,
Gigabit Ethernet 1/0/1 and Gigabit Ethernet 1/0/9.
console(config)#management access-list mlist
console(config-macal)# permit gigabitethernet 1/0/1 priority 1
console(config-macal)# permit gigabitethernet 1/0/9 priority 1
console(config-macal)# exit
console(config)# management access-class mlist
The following example shows how to configure all the interfaces to be
management interfaces except for two interfaces, Gigabit Ethernet 1/0/1 and
1/0/9.
console(config)# management access-list mlist
console(config-macal)# deny gigabitethernet 1/0/1 priority 1
console(config-macal)# deny gigabitethernet 1/0/9 priority 2
console(config-macal)# permit priority 2
console(config-macal)# exit
console(config)# management access-class mlist
show management access-class
Use the show management access-class command to display information
about the active management access list.
Syntax
show management access-class
1042
Security Commands