Radius-Server Timeout - Dell N1100-ON Reference Manual

console(config)#interface vlan 1
console(config-if-vlan1)#ip address dhcp
console(config-if-vlan1)#exit
console(config)#radius-server source-interface vlan 1

radius-server timeout

Use the radius-server timeout command in Global Configuration mode to set
the interval for which a switch waits for a server to reply. To restore the
default, use the no form of this command.
Syntax
radius-server timeout timeout
no radius-server timeout
• timeout — Specifies the timeout value in seconds. (Range: 1–30)
Default Configuration
The default value is 15 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the interval for which a switch waits for a server to
reply to 5 seconds.
console(config)#radius-server timeout 5
retransmit
Use the retransmit command in RADIUS Server Configuration mode to
specify the number of times the RADIUS client retransmits requests to the
RADIUS server.
932
Security Commands