Gi1/0/3
show interfaces traffic-class-group
Use the show interfaces traffic-class-group command to display the Traffic
Class to Traffic Class Group mapping.
Syntax
show interfaces traffic-class-group [interface-id]
•
interface-id—A valid physical interface specifier.
Default Configuration
The default is to show the global traffic class group configuration.
Command Mode
Privileged Exec mode
User Guidelines
NOTE: This command is only available on N40xx series switches.
The interface-id parameter is optional. If specified, the TCG mapping table
of the interface is displayed. If omitted, the global configuration settings are
displayed (these may have been subsequently overridden by per-port
configuration).
The following information is displayed:
Field
Interface
Traffic Class Group The traffic class Group identifier.
Min-Bandwidth
0
0
Description
Displays the slot/port of the interface. If displaying the global
configuration, this output line is replaced with a Global Config
indication.
The minimum transmission bandwidth, expressed as a
percentage. A value of 0 means bandwidth is not guaranteed.
This is a configured value.
Data Center Technology Commands
0
0
0
0
1158