Authentication Order - Dell N1100-ON Reference Manual

Default Configuration
The default value is Disabled.
Command Mode
Global Configuration mode
User Guidelines
The administrator must ensure that any methods configured by the
Authentication Manager are enabled (e.g. enable IEEE 802.1x using the
dot1x system-auth-control command). Enable MAB using the dot1x mac-
auth-bypass command.
Example
console(config)# authentication enable

authentication order

This command sets the order of authentication methods used on a port. The
available authentication methods are Dot1x, MAB, and captive portal.
Ordering sets the order of methods that the switch attempts when trying to
authenticate a new device connected to a port. If one method is unsuccessful
or timed out, the next method is attempted.
Use the no form of this command to return the port to the default
authentication order.
Syntax
authentication order {dot1x [mab][captive-portal] | mab [dot1x] [captive-
portal] | captive-portal}
no authentication order
Default Configuration
There is no default configuration for this command.
Command Modes
Interface Configuration (Ethernet) mode
860
Security Commands