Debug Ip Sla Error Twamp Connection - Cisco ME 3400 Command Reference Manual

debug ip sla error twamp connection

debug ip sla error twamp connection
Use the debug ip sla error twamp connection command in privileged EXEC mode to enable debugging
output of Cisco IOS IP Service Level Agreements (SLAs) Two-Way Active Measurement Protocol
(TWAMP) showing exceptions during communication between the TWAMP client and server. Use the
no form of this command to disable debugging output.
Syntax Description source-ip
ip-address
Command Modes
Privileged EXEC
Command History Release
12.2(52)SE
Usage Guidelines
The debug ip sla error twamp connection privileged EXEC command displays messages about the
exceptions that occurred during TWAMP communications between the server and reflector.
The undebug ip sla error twamp connection command is the same as the no debug ip sla error twamp
connection command.
Use the debug ip sla error twamp connection command before using the debug ip sla trace twamp
Note
connection command because the debug ip sla error twamp connection command generates less
debugging output.
The debug ip sla error twamp connection command is supported in IPv4 networks.
Related Commands Command
debug ip sla error twamp
control reflector
debug ip sla error twamp
control server
debug ip sla error twamp
session
debug ip sla trace twamp
connection
Cisco ME 3400 Ethernet Access Switch Command Reference
B-12
debug ip sla error twamp connection [source-ip ip-address]
no debug ip sla error twamp connection [source-ip ip-address]
(Optional) Debug IP Performance Metrics (IPPM) TWAMP connections for
the specified source. Specify the source using the IP address of the client
device.
Modification
This command was introduced.
Appendix B Cisco ME 3400 Ethernet Access Switch Debug Commands
Description
Displays exceptions during communication between the IP SLAs
TWAMP server and reflector.
Displays exceptions during communication between the IP SLAs
TWAMP server and reflector.
Displays exceptions during communication between the IP SLAs
TWAMP sender and reflector.
Displays the normal communications between an IP SLAs TWAMP
client and server.
OL-9640-10