Cisco ME 3400 Command Reference Manual page 402

service-policy (interface configuration)
Examples This example shows how to apply plcmap1 as an output policy map:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# service-policy output plcmap1
This example shows how to remove plcmap2 from the port:
Switch(config)# interface gigabitethernet0/2
Switch(config-if)# no service-policy output plcmap2
You can verify your settings by entering the show running-config privileged EXEC command.
Related Commands Command
policy-map
show policy-map
show policy-map
interface [interface-id]
show running-config
Cisco ME 3400 Ethernet Access Switch Command Reference
2-374
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Description
Creates or modifies a policy map that can be attached to multiple ports to
specify a service policy.
Displays quality of service (QoS) policy maps.
Displays policy maps configured on the specified interface or on all
interfaces.
Displays the operating configuration.
OL-9640-10