Show Ip Sla Twamp Session - Cisco ME 3400 Command Reference Manual

show ip sla twamp session

show ip sla twamp session
Use the show ip sla twamp session command in user EXEC mode to display Cisco IOS IP Service Level
Agreements (SLAs) Two-Way Active Measurement Protocol (TWAMP) test sessions.
Syntax Description
source-ip ip-address
source-port
port-number
| begin
| exclude
| include
expression
Defaults Displays the IP SLAs TWAMP test sessions and results.
Command Modes User EXEC
Command History Release
12.2(52)SE
Usage Guidelines Use the show ip sla twamp session command to display information about IP SLAs TWAMP test
sessions.
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples The following is sample output from the show ip sla twamp session command:
Switch> show ip sla twamp session
Cisco ME 3400 Ethernet Access Switch Command Reference
2-484
show ip sla twamp session [source-ip ip address | source-port port-number] [ | {begin | exclude |
include} expression]
(Optional) Display results from the TWAMP test session on the specified IP
address.
(Optional) Display results from the TWAMP test session on the specified
port.
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
IP SLAs Responder TWAMP is: Enabled
Recvr Addr: 172.27.117.116
Recvr Port: 3619
Sender Addr: 172.27.111.225
Sender Port: 32910
Session Id: 172.27.117.116:533112:9C41EC42
Connection Id: 95
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
OL-9640-10