Cisco ME 3400 Command Reference Manual page 629

Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
dot1x [auth-fail-vlan |
guest-vlan |
no-auth-fail-vlan |
no-guest-vlan]
entity
envmon [fan |
shutdown | status |
supply | temperature]
ethernet
flash
hsrp
ipmulticast
mac-notification
change
move
threshold
msdp
ospf [cisco-specific |
errors | lsa | rate-limit |
retransmit |
state-change]
OL-9640-10
(Optional) Enable IEEE 802.1x traps. The keywords have these meanings:
auth-fail-vlan—(Optional) Generate a trap when the port moves to the
•
configured restricted VLAN.
guest-vlan—(Optional) Generate a trap when the port moves to the
•
configured guest VLAN.
no-auth-fail-vlan—(Optional) Generate a trap when a port tries to enter
•
the restricted VLAN, but cannot because the restricted VLAN is not
configured.
no-guest-vlan—(Optional) Generate a trap when a port tries to enter the
•
guest VLAN, but cannot because the guest VLAN is not configured.
Note When the snmp-server enable traps dot1x command is entered
(without any other keywords specified), all the IEEE 802.1x traps are
enabled.
(Optional) Enable SNMP entity traps.
Optional) Enable SNMP environmental traps. The keywords have these
meanings:
• fan—(Optional) Enable fan traps.
shutdown—(Optional) Enable environmental monitor shutdown traps.
•
status—(Optional) Enable SNMP environmental status-change traps.
•
supply—(Optional) Enable environmental monitor power-supply traps.
•
temperature—(Optional) Enable environmental monitor temperature
•
traps.
(Optional) Enable SNMP Ethernet traps.
(Optional) Enable SNMP flash notifications.
(Optional) Enable Hot Standby Router Protocol (HSRP) traps.
(Optional) Enable IP multicast routing traps.
(Optional) Enable MAC address notification traps.
(Optional) Enable MAC address change notification traps.
(Optional) Enable MAC address move notification traps.
(Optional) Enable MAC address table threshold traps.
(Optional) Enable Multicast Source Discovery Protocol (MSDP) traps.
(Optional) Enable Open Shortest Path First (OSPF) traps. The keywords have
these meanings:
• cisco-specific—(Optional) Enable Cisco-specific traps.
• errors—(Optional) Enable error traps.
• lsa—(Optional) Enable link-state advertisement (LSA) traps.
rate-limit—(Optional) Enable rate-limit traps.
•
retransmit—(Optional) Enable packet-retransmit traps.
•
state-change—(Optional) Enable state-change traps.
•
Cisco ME 3400 Ethernet Access Switch Command Reference
snmp-server enable traps
2-601