Cisco ME 3400 Command Reference Manual page 592

show rep topology
sw5_multseg_3400 Gi0/14
sw2_multseg_3750 Gi1/1/2
sw2_multseg_3750 Gi1/1/1
sw1_multseg_3750 Gi1/1/2
This is a sample output from the show rep topology command when the edge ports are configured to
have no REP neighbor:
Switch # show rep topology
REP Segment 2
BridgeName
---------------- ---------- ----
sw8-ts8-51
sw9-ts11-50
sw9-ts11-50
sw1-ts11-45
sw1-ts11-45
sw8-ts8-51
This example shows output from the show rep topology detail command:
Switch# show rep topology detail
REP Segment 2
repc_2_24ts, Fa0/2 (Primary Edge)
Alternate Port, some vlans blocked
Bridge MAC: 0019.e714.5380
Port Number: 004
Port Priority: 080
Neighbor Number: 1 / [-10]
repc_3_12cs, Gi0/1 (Intermediate)
Open Port, all vlans forwarding
Bridge MAC: 001a.a292.3580
Port Number: 001
Port Priority: 000
Neighbor Number: 2 / [-9]
repc_3_12cs, Po10 (Intermediate)
Open Port, all vlans forwarding
Bridge MAC: 001a.a292.3580
Port Number: 080
Port Priority: 000
Neighbor Number: 3 / [-8]
repc_4_12cs, Po10 (Intermediate)
Open Port, all vlans forwarding
Bridge MAC: 001a.a19d.7c80
Port Number: 080
Port Priority: 000
Neighbor Number: 4 / [-7]
repc_4_12cs, Gi0/2 (Intermediate)
Alternate Port, some vlans blocked
Bridge MAC: 001a.a19d.7c80
Port Number: 002
Port Priority: 040
Neighbor Number: 5 / [-6]
<output truncated>
Cisco ME 3400 Ethernet Access Switch Command Reference
2-564
Chapter 2 Cisco ME 3400 Ethernet Access Switch Cisco IOS Commands
Open
Open
Open
Sec Open
PortName Edge Role
----
Gi0/2 Pri* Open
Gi1/0/4 Open
Gi1/0/2 Open
Gi0/2 Alt
Po1 Open
Gi0/1 Sec* Open
OL-9640-10