Cisco ME 3400 Command Reference Manual page 858

debug platform tcam
read {reg | ssram | tcam}
search
write {forw-ram | reg |
tcam}
Though visible in the command-line help strings, the log l3 ipv6 {acl {input | output} | local | qos |
Note
secondary} keywords are not supported.
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History Release
12.2(25)EX
Usage Guidelines
The undebug platform tcam command is the same as the no debug platform tcam command.
Related Commands Command
show debugging
Cisco ME 3400 Ethernet Access Switch Command Reference
B-74
Appendix B
Display TCAM-read debug messages. The keywords have these
meanings:
reg—Display TCAM-register read debug messages.
•
ssram—Display synchronous static RAM (SSRAM)-read debug
•
messages.
tcam—Display TCAM-read debug messages.
•
Display supervisor-initiated TCAM-search results debug messages.
Display TCAM-write debug messages. The keywords have these
meanings:
forw-ram—Display forwarding-RAM write debug messages.
reg—Display TCAM-register write debug messages.
tcam—Display TCAM-write debug messages.
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Cisco ME 3400 Ethernet Access Switch Debug Commands
OL-9640-10